Blemished D-Mode Switch - Yamaha Wolverine X2 1000 (NOT RMAX)

DOES NOT fit the RMAX 1000! Click HERE for Blemished RMAX Version

Blemished Units! These are brand new switches that did not make it through our quality screening for cosmetic reasons. They will either have a small scratch on the cover where you can see some of the blue light coming through or the black coating on the switch cover will be thin on the side where you can see some of the blue light coming through. Other than cosmetics, they pass all other quality tests. See images for examples of what they could look like. 

A cost effective solution to adding the drive mode switch to your 2024 Wolverine X2 1000.

The Offroad Designworks drive mode switch for the 2024 and up Yamaha Wolverine X2 1000 allows you to quickly switch between SPORT, TRAIL, and CRAWL modes on your Wolverine X2 1000. Both models of the Wolverine X2 1000 (R-Spec and XT-R) are pre-wired for this switch so there is no wiring modifications needed. Completely plug and play!
Installation takes about 15 minutes. Comes with installation instructions. You can also click here for the RMAX version install video which is very similar.

Each switch is assembled and tested right here in northern Utah! 

Add a pack of 12v accessory leads for 50% off when bought with a d-mode switch! Discount will automatically be applied in your shopping cart.

Fits the following models:

• 2024-2026 Yamaha Wolverine X2 1000 R-Spec
• 2024-2026 Yamaha Wolverine X2 1000 XT-R

DOES NOT fit Wolverine 850 and 700 models!